Selected edges must form a continual edge as viewed from the Top View.Selection of bottom edges only is unpredictable and will likely return undesirable paths in many situations however, it will return correct paths in some situations. After doing so, you will need to manually set the Final Depth for the operation. It is best to select the top edges (highest edges) for the selection.The Profile operation is capable of profiling open-edges (one or more continuous edges that do not form a loop as seen from the Top View).Advanced properties will be located here, if any. Make additional adjustments to the operation by modifying the operation's properties in the Data tab of the Property View. You have to adjust the properties, especially the final depth, carefully, a mistake might destroy your work pieceĪ Start point can be enabled from the Operation tab in the Tasks Window editor, using a location defined in the Property View → Data → Start Point. Important Note: Path Profile doesn't take care of other details of the object. Click the OK button or the Cancel button to create or cancel the operation. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |